Hey guys, new in thread here. I got issue with the Front Endlink with NTR R3. The front endlink does not have enough clearance to the wheel hub, so its damaged by the bracket on the wheelhub, is this an installation issue? Do i need to change the direction of the endlink mount on the...
Hi guys, I had a shop install some ohlins coilovers and SPL FLCA. I noticed some contact between the tie rod and the upper arm. See pics. What could be the issue? Iām using 2 big spacers above the bearing for the SPL arms, and Iām lowered about 1.25 inches
Up for sale are Passenger and driver side rear control arms set.
-rear upper control arms
-rear traction links
-rear toe links with eccentric lockouts
Less than 500 miles on this. Almost $2k in arms. Sold as a set $1,300 shipped.
**Update**
Thanks to forum member @Msoupe - the shop fixed the mistake and I'm back in business.
The 6 spacers included with the FLCAs (3 for each side), are only to be used as needed, if the car is lowered. Since my car was is not lowered, no spacers should be used. SPL designed the part to...
Hey guys I just installed SPL lower control arms, bumpsteer tie rods and front end links. After finishing up with the alignment took the car for a spin and I got a chassis stabilization error. I checked the ride height sensor it seems to be fine, I even used BM3 to scan the car and saw no error...
Iām looking around for upgrading suspension coil overs and other suspension parts. Thereās been couple few suspension parts out there: SPL parts, BC racing, Megan racingās just to name a few but has anyone fully upgraded their suspension? Such as end links, lateral links and traction arms.