Driveway Labs Gear Selector Lockout

[Carl - Driveway Labs]

Placeholder for follow on product drop but here is what I'm finishing up

Gear Selector Lockout Plate for the track folks that are stuck using hair ties or whatever other rigged up method to keep the selector from popping back into "drive"

Sponsored

 

[kyle9]

Might be tough to pop that in with gloves on when about to pull out onto the track though

 

[Carl - Driveway Labs]

Might be tough to pop that in with gloves on when about to pull out onto the track though

possibly, I didn't intend to 3d print them but with what people are asking for that might be the route to go.

I'm adding a little tab to one side to add an easy out method and help it go in

 

[EvilMKV]

Like this option better than the hair ties I've seen lol

I'd be in for one to keep in the glove box for a well priced 3D printed unit.

 

[kyle9]

possibly, I didn't intend to 3d print them but with what people are asking for that might be the route to go.

I'm adding a little tab to one side to add an easy out method and help it go in

The challenge is that it's still not a guarantee to go in correctly. Usually we're sitting on the grid with the car in park/off for 5-20 minutes before going out on track and only when they release cars would you put the car in drive.

The elastic band around the gear selector can stay in place when the car is in park and then is already applying force to keep the car in manual mode when the car is switched into drive/manual.

If people want these then by all means sell it to them though

 

[Carl - Driveway Labs]

The challenge is that it's still not a guarantee to go in correctly. Usually we're sitting on the grid with the car in park/off for 5-20 minutes before going out on track and only when they release cars would you put the car in drive.

The elastic band around the gear selector can stay in place when the car is in park and then is already applying force to keep the car in manual mode when the car is switched into drive/manual.

If people want these then by all means sell it to them though

you do you, I only do things for 2 reasons.

Business is always a second or third thought for me because quite frankly, I don't need the money to pay my bills and I'm not a greedy dick which is why I'm charging under $3k for the same quality wheels that HRE charges $3k per wheel and is made on the same machine

1: I want it so I make it available for others
2: I'm asked for it

also, i think that the e-brake can be applied while in drive. Let me test

 

[Isaleus]

Apparently this is to spicy to view without creating a account

 

[Carl - Driveway Labs]

Apparently this is to spicy to view without creating a account

it's linked to my feet finder account 🫣

no I had to turn on 18 and above for my business account, it's dumb but Zuckerberg will ban you for anything his AI nazi bots want

 

[Renegadmelons]

possibly, I didn't intend to 3d print them but with what people are asking for that might be the route to go.

I'm adding a little tab to one side to add an easy out method and help it go in

Might I suggest instead of a tab, you use like a hook? Don't need to like fit our entire fingers under, but if we're having gloves, hook or loop might give a bit more traction than just a tab

Sponsored